Associate - Networking Exam v1.0

Page:    1 / 5   
Exam contains 61 questions
Expand All

How is a switch different from a hub?

  • A. A switch operates at a lower, more efficient layer of the OSI model.
  • B. A switch tracks MAC addresses of all connected devices.
  • C. A switch decreases the number of broadcast storms.
  • D. A switch does not include any latency into the frame transfer time.


Answer : B

If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

  • A. Multicast
  • B. Broadcast
  • C. Anycast
  • D. Unicast


Answer : A

A network administrator wants to use a subnet that will only have two host addresses. Which subnet mask meets this requirement?

  • A. 255.255.255.248
  • B. 255.255.255.252
  • C. 255.255.255.254
  • D. 255.255.255.256


Answer : B

Which flags are used in the TCP header to initiate and end TCP connections or sessions?

  • A. Initiate = Acknowledge (ACK) End = Synchronize (SYN)
  • B. Initiate = Acknowledge (ACK) End = Finish (FIN)
  • C. Initiate = Synchronize (SYN) End = Finish (FIN)
  • D. Initiate = Finish (FIN) End = Synchronize (SYN)


Answer : C

A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients. Which IPv6 address prefix will the default gateway have on a client?

  • A. fd01::/64
  • B. fe08::/64
  • C. fe80::/64
  • D. ff02::/8


Answer : C

Which fields are mandatory TLVs in a LLDP PDU frame?

  • A. System Capabilities and Management Address
  • B. Chassis ID, Port ID, and Time-to-Live
  • C. IP Address, Default Gateway, and DNS
  • D. Port Description, System Name, and System Description


Answer : B

Reference:
https://en.wikipedia.org/wiki/Link_Layer_Discovery_Protocol#:~:text=Each%20LLDP%20frame%20starts%20with,and%20length%20fields%20are%
200

Which IEEE standard defines the Data Link Layer, Discovery protocol?

  • A. 802.1AB
  • B. 802.1AX
  • C. 802.1D
  • D. 802.1W


Answer : A

Reference:
http://www.ieee802.org/3/frame_study/0409/blatherwick_1_0409.pdf

What is the bandwidth of an RPM for a C9010 Network Director?

  • A. 200 Mbps
  • B. 2.56 Mbps
  • C. 1.52 Tbps
  • D. 2.56 Tbps


Answer : D

Reference:
http://i.dell.com/sites/doccontent/shared-content/data-sheets/en/documents/dell_networking_c9000_specsheet.pdf

What is the default route preference value for a Border Gateway Protocol (BGP) internal route?

  • A. 40
  • B. 110
  • C. 200
  • D. 253


Answer : C

Reference:
https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/networking-n2128px-on_Administrator-Guide_en-us.pdf page
1528.

Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

  • A. MXL
  • B. M6220
  • C. M6348
  • D. M8024-K


Answer : A

Reference:
https://i.dell.com/sites/doccontent/shared-content/data-sheets/en/Documents/PowerEdge_M_Series_Blades_IO_Guide.pdf

A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.
Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?

  • A. Switch checks its routing table and forwards the packet accordingly.
  • B. Switch duplicates the packet and sends it to all interfaces.
  • C. Switch replies back to the source with an ICMP Reject packet.
  • D. Switch drops the packet.


Answer : A

Which message is sent by a router when TTL expires?

  • A. Echo request
  • B. Time exceeded
  • C. Destination unreachable
  • D. Echo reply


Answer : B

Which formula is used for calculating OSPF interface costs?

  • A. Reference bandwidth "" interface bandwidth
  • B. Reference bandwidth / interface bandwidth
  • C. Reference bandwidth + interface bandwidth
  • D. Interface bandwidth / reference bandwidth


Answer : D

What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?

  • A. 00:C4:4F
  • B. 00:C4:4F:23
  • C. 23:AF:4A
  • D. 4F:23:AF:4A


Answer : A

Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

  • A. Store-and-forward
  • B. Fragment-free
  • C. Unicast
  • D. Cut-through


Answer : D

Page:    1 / 5   
Exam contains 61 questions
Expand All

Talk to us!

Have any questions or issues ? Please dont hesitate to contact us

[email protected]

Certlibrary.com is owned by MBS Tech Limited: Room 1905 Nam Wo Hong Building, 148 Wing Lok Street, Sheung Wan, Hong Kong. Company registration number: 2310926
Certlibrary doesn't offer Real Microsoft Exam Questions. Certlibrary Materials do not contain actual questions and answers from Cisco's Certification Exams.
CFA Institute does not endorse, promote or warrant the accuracy or quality of Certlibrary. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Terms & Conditions | Privacy Policy